U-Line 1175BEV repair
Origins 1000 beverage center, Origins 1000. Service for this model across Tampa Bay.
- Model
- 1175BEV
- Type
- Origins 1000 beverage center
- Series
- Origins 1000
- Years
- Origins 1000
- Brand
- U-Line
About the 1175BEV
Bars, kitchens and entertainment rooms are where the U-Line 1175BEV goes. This beverage center belongs to the Origins 1000 line. Its control has a service-mode model select, and error codes report sensor and circuit alerts.
Warm drinks on the upper shelves point us to the fan or thermistor on a 1175BEV, so we test both. Frost on the back wall suggests a door that is not sealing, which sends us to the gasket and its corners. If the control shows an error after a power surge, we read it and test the board. A lint-filled grille gets cleaned because it makes the compressor run long.
What we check on a 1175BEV visit
- Fan and thermistor when upper shelves run warm
- Back wall frost and gasket corners
- Control error after a power surge, and the lint-filled grille
Key features
- Origins 1000 beverage center
- Control with a model select in service mode
- Intended for a bar, kitchen or entertainment area
- Error-code control that reports sensor and circuit alerts
The model number is on the serial label: inside the cabinet near the top, on the side wall or behind the front grille. We are an independent repair company, not affiliated with U-Line Corporation.
U-Line beverage center codes
Codes listed for U-Line beverage centers. Which ones a unit can show depends on its control generation, so we confirm by the full model number.
Other U-Line beverage center models
Origin 1000 Series1024BEVEarly undercounter beverage centerOrigin 1000 Series1224BEV24-inch Origin beverage centerEchelon Series2218BEV18-inch Echelon beverage centerEchelon Series2224BEV24-inch Echelon beverage center3000 Series (Modular)3036BVWC36-inch paired beverage and wine unit5 Class CollectionHBD52424-inch dual-zone beverage center1 Class CollectionHBV12424-inch glass-door beverage center5 Class CollectionHBV515Slim 15-inch stainless beverage center1175BEV questions
My 1175BEV shows an error after a storm. What do you do?
We read what the control displays, then test the sensors and circuits it monitors. A power surge can affect the board, so we test it before replacing parts.
There is frost on the back wall. Is that a leak?
It usually points to humid air entering around the gasket. We inspect the seal, especially at the corners.