U-Line 1024BEV repair
Early undercounter beverage center, Origin 1000 Series. Service for this model across Tampa Bay.
- Model
- 1024BEV
- Type
- Early undercounter beverage center
- Series
- Origin 1000 Series
- Years
- Origin 1000 Series
- Brand
- U-Line
About the 1024BEV
One of the earlier Origin-series beverage centers, the U-Line 1024BEV has plain controls with no touch panel. Shelving is laid out for cans and bottles, and the cabinet is made to slide under a counter.
Since a unit like this has simple parts, the 1024BEV checks come down to the parts that do the switching. We listen as the compressor starts, because a weak start relay is slow to engage. The thermostat contacts are tested, as constant cycling wears them. Lastly, the door gasket is inspected for compression, since a flattened seal no longer closes flat against the frame.
What we check on a 1024BEV visit
- Compressor start behavior and the start relay
- Thermostat contacts after years of cycling
- Door gasket compression and flat contact with the frame
Key features
- Early Origin-series beverage center
- Plain controls without a touch panel
- Shelving for cans and bottles
- Undercounter installation
The model number is on the serial label: inside the cabinet near the top, on the side wall or behind the front grille. We are an independent repair company, not affiliated with U-Line Corporation.
U-Line beverage center codes
Codes listed for U-Line beverage centers. Which ones a unit can show depends on its control generation, so we confirm by the full model number.
Other U-Line beverage center models
Origin 1000 Series1224BEV24-inch Origin beverage centerEchelon Series2218BEV18-inch Echelon beverage centerEchelon Series2224BEV24-inch Echelon beverage center3000 Series (Modular)3036BVWC36-inch paired beverage and wine unit5 Class CollectionHBD52424-inch dual-zone beverage center1 Class CollectionHBV12424-inch glass-door beverage center5 Class CollectionHBV515Slim 15-inch stainless beverage center5 Class CollectionHBV51818-inch convection beverage center1024BEV questions
My 1024BEV hums but takes a long time to start cooling. Why?
A start relay that has weakened can delay the compressor. We test the relay and the thermostat contacts, and tell you which one needs replacing.
The door seems loose on the cabinet. What do you check?
A compressed gasket stops closing flat. We look at the whole seal and replace it if it has lost its shape.