U-Line 2218BEV repair
18-inch Echelon beverage center, Echelon Series. Service for this model across Tampa Bay.
- Model
- 2218BEV
- Type
- 18-inch Echelon beverage center
- Series
- Echelon Series
- Years
- Echelon Series
- Brand
- U-Line
About the 2218BEV
At 18 inches, the U-Line 2218BEV is a slim Echelon-line beverage center built in under a counter. Shelving takes a mix of cans and bottles, and the digital control comes from the Echelon series.
A narrow cabinet in a busy kitchen or bar gets opened constantly, so we look at the gasket on a 2218BEV before anything else; it may be worn flat. Loaded shelves come next, because a bent or worn shelf support lets a shelf sag. Finally, we clean the coil of dust and lint, a job that keeps the compressor from running longer than it should.
What we check on a 2218BEV visit
- Gasket flattening from constant door openings
- Shelf supports for bending or wear
- Condenser coil coated with dust and lint
Key features
- Echelon-line beverage center, 18 inches wide
- Shelving for mixed cans and bottles
- Echelon-series digital control
- Installed built in beneath the counter
The model number is on the serial label: inside the cabinet near the top, on the side wall or behind the front grille. We are an independent repair company, not affiliated with U-Line Corporation.
U-Line beverage center codes
Codes listed for U-Line beverage centers. Which ones a unit can show depends on its control generation, so we confirm by the full model number.
Other U-Line beverage center models
Origin 1000 Series1024BEVEarly undercounter beverage centerOrigin 1000 Series1224BEV24-inch Origin beverage centerEchelon Series2224BEV24-inch Echelon beverage center3000 Series (Modular)3036BVWC36-inch paired beverage and wine unit5 Class CollectionHBD52424-inch dual-zone beverage center1 Class CollectionHBV12424-inch glass-door beverage center5 Class CollectionHBV515Slim 15-inch stainless beverage center5 Class CollectionHBV51818-inch convection beverage center2218BEV questions
A shelf in my 2218BEV tilts when loaded. Can it be fixed?
We examine the supports for bending or wear. A damaged support is replaceable, and we quote it in writing before ordering.
How do you tell the gasket is done?
We run a hand along it and check for flat spots, cracks or gaps at the corners. A seal that no longer springs back should be replaced.