U-Line BI1215 repair
Built-in crescent ice maker, Origin 1000 Series. Service for this model across Tampa Bay.
- Model
- BI1215
- Type
- Built-in crescent ice maker
- Series
- Origin 1000 Series
- Years
- Origin 1000 Series
- Brand
- U-Line
About the BI1215
Crescent ice from the BI1215 comes out of a harvest cycle: the evaporator freezes the water, warms for a moment, and the cubes drop into the bin. This undercounter machine carries a number from the Origin 1000 Series, with controls from that earlier design.
The evaporator tells most of the story on a BI1215, because scale from the supply can coat it and leave cubes stuck or undersized. We descale it, then look at the bin-full sensor and the drain, since meltwater that stays in the bin or ice that stops with room left both trace back there. Pricing is written first.
What we check on a BI1215 visit
- Evaporator scale, when cubes cling or shrink
- Bin-full sensor, when production stops with space left
- Meltwater drainage from the bin
Key features
- Built-in crescent ice maker from the Origin line
- Harvest-cycle ice production
- Origin-series controls
- Undercounter installation
The model number is on the serial label: inside the cabinet near the top, on the side wall or behind the front grille. We are an independent repair company, not affiliated with U-Line Corporation.
U-Line ice machine codes
Codes listed for U-Line ice machines. Which ones a unit can show depends on its control generation, so we confirm by the full model number.
Other U-Line ice machine models
Modular 3000 Series3018CLR18-inch Modular clear ice machineModular 3000 Series3045CLRWide Modular clear ice machineADA SeriesACP11515-inch ADA clear ice machineADA SeriesACR01414-inch ADA crescent ice makerADA SeriesACR01515-inch ADA crescent ice makerADA SeriesACR11515-inch ADA crescent ice makerIce MachineADA15IMOlder 15-inch ADA ice makerADA SeriesANB11515-inch ADA nugget ice machineBI1215 questions
Why are the cubes from my BI1215 small?
Scale on the evaporator keeps ice from forming and releasing properly. Descaling the surface usually restores normal cubes, and we check the water supply to see whether the buildup will return.
Why does my BI1215 stop while the bin is not full?
The bin-full sensor can read the level wrongly, which ends the cycle early. We test its response and clean the area around it.